Best of Savannah
Roofers|November 15, 2026

Metal Roof Cost in Savannah, GA: Standing Seam vs. Screw-Down Prices (2026)

By Best of Savannah

Metal roof cost in Savannah, GA depends mostly on one choice: screw-down panels or standing seam. The short answer: published estimates for the Savannah area run from about $7 to $10 per square foot installed at the low end to $12 to $19 per square foot for standing seam on a complex roof. For a 2,000-square-foot roof, that is roughly $13,000 to $20,000 at the low end and $24,000 to $38,000 for standing seam on a complicated roofline.

Those ranges come from different sources that do not fully agree, so treat them as budgeting numbers, not quotes. Below is where each figure comes from, what moves the price on the coast, and how to compare bids from Savannah roofers.

TL;DR: Metal Roof Prices in Savannah

  • Low-end estimate: HomeBlue's Savannah page lists $7 to $10 per square foot installed, or about $13,100 to $20,500 for a 2,000-square-foot roof.
  • Standing seam on a complex roof: RoofCrafters, a Savannah roofer, puts it at $12 to $19 per square foot, or $24,000 to $38,000 for 2,000 square feet.
  • Screw-down (exposed fastener) panels are the cheaper metal option. Standing seam costs more because the fasteners are hidden.
  • Near salt water, read the warranty before choosing a material. Some steel panel warranties exclude homes close to the coast, and aluminum is often recommended instead.
  • Historic District homes generally need MPC review for visible exterior changes, including a new roof material.
  • Best move: get two or three itemized quotes that name the panel, gauge, finish and warranty.

How Much Does a Metal Roof Cost in Savannah?

No public source tracks Savannah metal roof prices on its own. The best you can do is compare a few published estimates and see where they overlap.

HomeBlue's Savannah metal roof page, published in September 2024, lists an average of $7 to $10 per square foot installed. Its table works out to about $9,800 to $15,400 for a 1,500-square-foot roof and $13,100 to $20,500 for 2,000 square feet.

RoofCrafters on Abercorn Street publishes a Savannah roof cost guide that is much higher for standing seam: $12 to $19 per square foot on a complex roof, or $24,000 to $38,000 for 2,000 square feet. Its separate Georgia metal roof page gives a wider $8,000 to $24,000 or more for an average metal roof replacement, with labor alone at $3 to $7 per square foot.

The gap between those numbers is real. It mostly reflects the panel type and how complicated the roof is. A simple gable roof with screw-down panels sits near the bottom. A steep, cut-up roof with standing seam sits near the top.

Screw-Down vs. Standing Seam: Which Costs Less?

Screw-down (exposed fastener) panels

These are the ribbed panels you see on barns, sheds and many coastal cottages. The screws go straight through the panel, and each one has a rubber washer to seal the hole. They are the cheaper way into metal because the panels are simpler and faster to install.

The trade-off is maintenance. Those washers age in the sun, and every screw is a possible leak point. Ask any roofer you hire how often they recommend checking and replacing fasteners.

Standing seam panels

Standing seam panels lock together at raised seams, and the fasteners are hidden underneath. That means fewer exposed holes, a cleaner look, and room for the metal to expand and contract in the heat. It also means more labor and more expensive panels, which is why it sits at the top of every cost guide.

Two local roofers in our directory show standing seam work on their own sites: Savannah Roofing Experts on Fortilla Road and RoofCrafters, which runs a full learning section on metal roofing.

Steel or Aluminum: Does Salt Air Change the Price?

It can. On the Georgia coast, salt air is the main reason metal roof quotes vary.

Most residential metal roofs use coated steel, often Galvalume. Some manufacturers limit or exclude their warranties for buildings close to salt water. The exact distance differs by manufacturer. One Galvalume warranty we reviewed cuts coverage to five years between one mile and half a mile from salt water and offers none closer than that.

Aluminum costs more, but it does not rust the way steel can. RoofCrafters' Georgia guide lists aluminum at about $10,000 to $20,000 on a standard home, compared with $8,000 to $15,000 for steel, and calls aluminum "ideal for coastal areas."

That matters for homes on Tybee Island, Wilmington Island, Isle of Hope, Skidaway and other marsh-front addresses. Some coastal paint warranties also require regular freshwater rinsing, so read the maintenance terms too.

Local tip: Ask each roofer to write the manufacturer's salt-water distance limit for your exact panel on the quote, along with any rinsing requirement. If your house is near the marsh or the river, a cheaper steel quote may come with a weaker warranty than it seems.

What Else Pushes a Metal Roof Quote Up?

  • Tear-off: removing the old shingles and hauling them away adds cost. Our roof replacement cost guide cites about $1 per square foot for removal.
  • Rotted decking: long-running leaks in a humid climate can damage the wood under the old roof. Ask for a per-sheet decking price in writing.
  • Roof shape: hips, valleys, dormers, chimneys and skylights all mean more custom flashing and trim.
  • Panel gauge and finish: thicker metal and premium paint finishes cost more but resist dents and fading better.
  • Underlayment: a high-temperature synthetic underlayment is common under metal and is worth seeing listed on the bid.

Do Historic District Homes Need Approval for a Metal Roof?

Generally, yes. The Metropolitan Planning Commission says exterior changes visible from the public right-of-way in the Savannah Historic District require a Certificate of Appropriateness. Re-roofing jobs go through MPC review, sometimes with conditions on color or metal details.

Plan for that time before you sign a contract. If your house is a restoration project, a contractor with historic experience can help. Start with our historic restoration contractors and our guide to historic home restoration contractors.

Is a Metal Roof Worth It in Savannah?

For many coastal homeowners, it can be. RoofCrafters' guide says metal roofs can last 40 to 70 years depending on the material, compared with a much shorter life for most asphalt shingles. If you plan to stay in the house for decades, the higher upfront cost spreads out over a longer life.

Metal is a harder sell if you plan to sell soon, if your roof is very complex, or if a tight budget points you toward architectural shingles. Our full roof replacement cost breakdown compares metal with shingles and tile.

If you are replacing a roof after a storm, deal with the insurance claim and any emergency tarping first. Our storm damage roof repair guide walks through that process, and the storm damage roofers listings can help.

Who Installs Metal Roofs in Savannah?

Every roofer in our directory has a local Savannah address. Of the ones we checked in November 2026, these list metal roofing on their own websites:

  • RoofCrafters (6605 Abercorn St) lists metal roofing and publishes metal roof cost guides.
  • Savannah Roofing Experts (205 Fortilla Rd) shows standing seam installations and says it installs metal roofs.
  • South Shore Roofing (105 Wheeler St) lists both residential and commercial metal roofing.

For businesses, warehouses and low-slope buildings, browse the commercial roofing listings. For homes, the residential roofing listings and our best roofers in Savannah guide are good places to start. Confirm services, licensing and insurance directly with any company before you sign.

How Do You Compare Metal Roof Quotes?

  • Panel type: screw-down or standing seam, named clearly.
  • Metal and gauge: steel or aluminum, and the thickness.
  • Finish and warranty: the paint system, the manufacturer's warranty, and any coastal limits.
  • Workmanship warranty: how long the roofer stands behind the installation.
  • Tear-off and decking: whether removal is included and the price per sheet of decking.
  • Permits and review: who pulls the permit and handles any MPC paperwork.

If you are still budgeting for a home in the area, our cost of living in Savannah guide covers insurance, taxes and other ownership costs.

Bottom Line

A metal roof in Savannah, GA usually costs more upfront than shingles, and the range is wide. Published estimates run from about $7 to $10 per square foot at the low end to $12 to $19 per square foot for standing seam on a complex roof. Screw-down panels keep the cost down. Standing seam costs more but leaves fewer exposed fasteners to maintain.

Near the coast, ask about aluminum and get the warranty's salt-water limits in writing. In the Historic District, plan for MPC review. Then collect two or three itemized quotes from the Savannah roofers directory and compare them line by line.